Stratasys uPrint, Service Manual, Page: 122 / 383

uPrint/uPrint SE Service Manual 4-75
Installing the toggle bar
1.
Align the toggle bar with the translator and reinstall the washer over the bottom
mounting post. See Figure 4-125.
Figure 4-125: Toggle bar alignment
2.
Push the toggle assembly back into position.
3.
Reinstall the lower washer and spring.
4.
Using a
7
⁄
64
” allen wrench, reinstall the lower spring screw.
5.
Reinstall the upper spring and washer.
6.
Using a
7
⁄
64
” allen wrench, reinstall the upper spring screw.
7.
Using a
7
⁄
64
” allen wrench, reinstall the heat shield.
8.
Reinstall the model tip (right side) and support tip (left side) by pushing up into place.
9.
Using a
7
⁄
64
” allen wrench tighten the tip mounting screws.
10.
Reinstall the head cover.
11.
Power the printer up.
12.
Perform calibrations. See Offset Calibrations on page 5-2.
Reinstall washer
Align toggle bar