Stratasys uPrint, Service Manual, Page: 94 / 383

uPrint/uPrint SE Service Manual 4-47
Figure 4-76: Power switch connector locations
5.
Press the Power Switch tabs in and push it out of the housing. See Figure 4-77.
Figure 4-77: Removing the power switch
Installing the power switch
1.
Push the power switch into place on the power switch housing.
2.
Connect the yellow NC wire to the spade connector labeled “2a”, connect the green COM
wire to the spade connector labeled “2”, connect the black SW3 wire to the spade
connector labeled “1a” and connect the white SW2 wire to the spade connector labeled
“3”.
3.
Align the power switch housing with the mounting holes.
4.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 2 mounting screws.
5.
Reinstall the left side panel. See Installing the side panels on page 4-8.
6.
Install the top panel. See Installing the top panel on page 4-6.
Press tabs
to release
Press tabs
to release