Stratasys uPrint, Service Manual, Page: 180 / 383

uPrint/uPrint SE Service Manual 4-133
58.
Move the dial indicator to the front left of the Z stage and zero the dial indicator.
59.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given. See Figure 4-232.
Figure 4-232: XY guide rod leveling fixture
60.
Using a
5
⁄
32
” allen wrench, securely fasten the front left Y guide rod mounting screw.
61.
Move the dial indicator to the front right of the Z stage and zero the dial indicator.
62.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given.
63.
Using a
5
⁄
32
” allen wrench, securely fasten the front right Y guide rod mounting screw.
64.
Move the dial indicator to the rear right of the Z stage and zero the dial indicator.
65.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given.
66.
Using a
5
⁄
32
” allen wrench, securely fasten the rear right Y guide rod mounting screw.
67.
Repeat steps 53 - 66 until the XY table is completely level.
68.
Remove the XY guide rod alignment brackets.
69.
Remove the XY table leveling bracket and dial indicator.
70.
Move the Head Assembly to the full right travel position within the build envelope (as
viewed from the front of the printer).
71.
Insert the zero gauge block into the gauge. See Figure 4-233.
72.
Loosen the adjustment screw and insert the dial indicator into the fixture.
73.
Adjust the depth of the dial indicator so the gauge reads 0.500 mils and tighten the
adjustment screw. Recheck the reading.
74.
Remove the zero block gauge block from the fixture.