Stratasys uPrint, Service Manual, Page: 375 / 383

9-2
Hard Drive Installation Checklist
If you have any questions before or during installation, do not hesitate to call your Customer
Support provider.

Replace the hard drive.

Remove the system CD from the electronics bay.

Verify that all cables are connected correctly.

Clean and vacuum the system.

Power system up.

After 10 minutes to 45 minutes, the LCD will display
UPGRADE
and
Send Upgrade From Work
Station
along with the Dynamic IP Address of the system (the default system setting).
• If the system will be operating in a Dynamic environment, the UPGRADE can be
loaded from the PC.

Use the Manage 3D Printers button in CatalystEX to connect to the printer -Choose “Add
from Network...”
• If the system will be operating in a Static environment, choose
Set Network...
from the
display panel and enter the appropriate network addresses. The customer should
provide this information.

After all the addresses have been edited, select
Done
.

Use the Manage 3D Printers button in CatalystEX to connect to the printer - Choose “Add
Manually...”

Download the system software using the most current version. Download instructions for
performing the download procedure are located on the system software CD.

Once download is complete, system will reach “Idle”.

Using MaracaEX, “send” the .cal file from the CD to the system hard drive.

Replace the system CD to the electronics bay.

Load material.

Run a small test part to ensure part quality is acceptable and that the system is operating
properly.

Discuss any of the customer’s questions or issues with them.

Pack the old hard drive into the shipping box along with the RMA documentation and
shipping back to Stratasys.
Note: For convenience, the assigned IP address is visible in the display panel during
this process.
Note: The controller software must be downloaded before system operation can
continue.