Stratasys uPrint, Service Manual, Page: 356 / 383

uPrint/uPrint SE Service Manual 7-13
Figure 7-415: Tip shield placement
10.
Replace head cover and close the printer door.
11.
The printer will display
Tip Maintenance - Tips Replaced?
- press
Yes
to begin material load.
A.
The printer will display
Maintenance - Add/Remove
(flashing).
• If you want to replace a material carrier, do so now.
B.
Load the model and support material carriers by pushing in until they latch. Press
the
Load Selected
button.
12.
The printer will now begin to load material.
13.
After material loading is complete the printer will display
Tip Calibration - Install Modeling
Base And Build Calibration Part.
Tip calibration
Tip replacement requires Tip Calibration.
1.
Select
Start Part
(flashing) - the printer will run two calibration parts.
• The printer will automatically build a Z Calibration part, measure the part
and calibrate the Z Axis for tip depth and tip level (approximately 5 minutes).
The Z calibration is automatic.
• The printer will then automatically build an XY Calibration part
(approximately 10 minutes). You must inspect the XY Calibration part and
calibrate the X and Y axis for tip offset:
2.
When the XY Calibration part is complete the printer will display
Remove Part and Select
XY Adjustment - X:0, Y:0
3.
Remove the XY tip calibration part from the printer.
4.
Inspect the part and calibrate the X and Y axis, See Figure 7-416.
A.
Use the magnifier from the Startup kit to view the support road (shown in red).
B.
Identify the location on the +X or –X side of the part where the support road is
best centered within the model boundaries (shown in blue).
Note: If the head cover is not replaced the printer may not function properly.
Note: Make sure a NEW modeling base is installed before starting calibration.
Calibration results will be incorrect if a NEW modeling base is not used.
Tip shield NOT seated correctly Tip shield seated correctly