Stratasys uPrint, Service Manual, Page: 185 / 383

4-138
Z EOT (End of Travel) Sensor
Required Tools
•
1
⁄
4
” nut driver or standard screwdriver.
Hardware
• 6-32 x
3
⁄
8
” slotted screw (x1)
Removing the Z EOT sensor
1.
Open the chamber door.
2.
Raise the Z stage all of the way up.
3.
Disconnect the Z EOT sensor cable by pressing in on the tab and pulling outward. See
Figure 4-240.
Figure 4-240: Z EOT sensor cable location
4.
Using a
1
⁄
4
” nut driver or standard screwdriver, remove the mounting screw. See Figure
4-241.
Figure 4-241: Remove the mounting screw
5.
Remove the Z EOT Sensor.
Installing the Z EOT sensor
1.
Align the Z EOT sensor with the mounting hole.
2.
Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the mounting screw.
3.
Reconnect the Z EOT sensor cable.
4.
Close the chamber door.
Disconnect the Z EOT
cable
Remove the
mounting screw