Stratasys uPrint, Service Manual, Page: 80 / 383

uPrint/uPrint SE Service Manual 4-33
Installing the power distribution board
1.
Align the power distribution board with the mounting holes.
2.
Using a Phillips screwdriver, reinstall the 12 mounting screws.
3.
Reconnect the 10 cables to the front of the power distribution board.
4.
Carefully slide the electronics bay out 3 inches (76mm) and reconnect the 4 cables to the
back of the PDB.
5.
Carefully slide the electronics bay back into position.
6.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 8 mounting screws on the
left and right sides.
7.
Reinstall the I/O card. See Installing the I/O card on page 4-30.
8.
Close the electronics bay. See Closing the electronics bay on page 4-16.
9.
Reinstall the side panels. See Installing the side panels on page 4-8.
10.
Reinstall the top panel. See Installing the top panel on page 4-6.