Stratasys uPrint, Service Manual, Page: 357 / 383

7-14
C.
Read the number closest to this location. This is the required X Tip Offset
adjustment. If the number is on the -X side, a negative offset is required.
D.
Select
Increment
or
Decrement
to input the X offset adjustment - the value will
change in the upper display window (by default, the printer will be ready to
accept the X value).
E.
When you are satisfied with your X offset value,
Select Y
and repeat steps A- D to
identify and input the required Y Tip Offset adjustment.
Figure 7-416: Example XY Tip Offset Part.
This example requires an adjustment of X = + 2, Y = - 4
5.
Select
Done
after you have input the X and Y offsets. The printer will return to
Maintenance.
Run the XY calibration a second time to be sure the values changed the offset
properly.
6.
When finished, press
Done
until back at
Idle
.