Stratasys uPrint, Service Manual, Page: 93 / 383

4-46
Power Switch
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
Hardware
• 10-32 x
3
⁄
8
” slotted screws (x2)
Removing the Power Switch
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the left side panel. See Side Panels on page 4-7.
3.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 2 power switch housing
mounting screws. See Figure 4-75.
Figure 4-75: Power switch housing mounting screw locations
4.
Remove the white SW2 wire from the spade connector labeled “3”. Remove the black
SW3 wire from the spade connector labeled “1a”. Remove the yellow NC wire from the
spade connector labeled “2a”. Remove the green COM wire from the spade connector
labeled “2”. See Figure 4-76.
Remove the 2
mounting screws