Stratasys uPrint, Service Manual, Page: 78 / 383

uPrint/uPrint SE Service Manual 4-31
Power Distribution Board (PDB)
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
• Phillips screwdriver
Hardware
• 6-32 x
1
⁄
4
” Phillips pan head screws (x12)
• 10-32 x
1
⁄
2
” slotted screws (x8)
Removing the power distribution board
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Open the electronics bay. See Opening the electronics bay on page 4-15.
4.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
5.
Remove the I/O card. See Removing the I/O card on page 4-29.
6.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 4 screws on the left and
right side of the electronics bay and carefully slide the electronics bay out of the printer
about 3 inches (76mm). See Figure 4-55.
Figure 4-55: Electronics bay mounting screw locations
Remove the 4 right
side mounting screws
Remove the 4 left
side mounting screws