Stratasys uPrint, Service Manual, Page: 42 / 383

uPrint/uPrint SE Service Manual 3-7
Modeler Setup
In order to use MaracaEX on a network modeler, you must first create a modeler definition.
You can create modeler definitions by clicking the + button in the main window.
A modeler definition is made complete by specifying the following:
• Modeler name (You can use any descriptive name for the modeler.)
• Modeler
type
• Modeler IP address
You can delete a modeler definition by selecting the - button in the main window and then
choosing the modeler to delete from the current list of modelers.
Configuration
Clicking the properties icon, “Set up the display parameters”, in the main window will bring
up a dialog to select Metric or English units of measure. Click the green arrow to close the
window after making your selection. MaracaEX will now display numerical values in the
units you chose.
Status
MaracaEX machine status provides the ability to set the machines serial number and detailed
information about the current mechanical state of the machine.
• Position and Temperatures
• Versions
• Travel
Limits
• Filament
• Door
• Setting the Serial Number
Printer Status
Current Position The current X, Y and Z position in inches.
XYZ Scale/Inch
Scale factors in microsteps per inch.
Current / Total Layers The current build layer and the total number of layers in the model.
Current Curve
The current curve number of the model.
Head Temp The model liquefier temperature and its set point in C.
Head PWM
Not used.
Support Temp The support liquefier temperature and its set point in C (SST only).
Support PWM
Not used.
Chamber Temp The actual chamber temperature and its set point in C.