Stratasys uPrint, Service Manual, Page: 72 / 383

uPrint/uPrint SE Service Manual 4-25
Installing the controller board
1.
Align the pins of the Controller board with the P104 connector of the SBC and gently
press down in to position.
2.
Using a Phillips screwdriver, reinstall the 6 mounting screws.
3.
Reconnect the diagnostics DB-9 connector to the controller board.
4.
Using a standard screwdriver, tighten the 2 mounting screws.
5.
Reconnect the 3 ribbon cables to the PDB.
6.
Close the Electronics Bay. See Closing the electronics bay on page 4-16.
7.
From the workstation, open CatalystEX.
8.
Connect to the printer.
9.
Insert the printer firmware CD into the workstation CD drive.
10.
From the Printer Services tab, click on the Update Software button.
11.
Navigate CatalystEX to the Upgrade (.UPG) file on the printer firmware CD.
12.
The printer will load, reboot and verify the upgrade.