Stratasys uPrint, Service Manual, Page: 230 / 383

uPrint/uPrint SE Service Manual 5-21
Part Measurement Equations
Use the equation table below to record part measurements. Refer to these equations when
entering values in MaracaEX.
Front: _ ______ - ____ = ________
(A + B) + (B + C) - B
Right: _______ = ________
(C + G)
Left: _______ = ________
(A + E)
Rear: _ ______ - ____ = ________
(E+ F) + (F + G) - F
Left Rear: _ ______ - ____ = ________
(C + D) + (D + E) - D
Left Front: _ ______ - ____ = _______
(A + D) + (D + G) - D
Figure 5-312: Part based calibration measurement locations