Stratasys uPrint, Service Manual, Page: 188 / 383

uPrint/uPrint SE Service Manual 4-141
Chamber Heaters
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
•
3
⁄
8
” nut driver.
Hardware
• 10-32 x
3
⁄
8
” slotted screws (x8)
• 10-32 x
1
⁄
2
” slotted screws (x4)
• 10-32 x
1
⁄
8
” nut (x4)
Removing the right side heater
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 4 mounting screws and
remove the heater panel. See Figure 4-246.
Figure 4-246: Right side heater panel mounting screw locations
4.
Remove the black power wire from the right mounting post with a
3
⁄
8
” nut driver. See
Figure 4-247.
Remove the 4
mounting screws