Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 687 / 774

■
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use
by a dynamic ATM 1483 subinterface.
■
For detailed information about how to use this command, see “atm bulk-config”
on page 642.
■
Example
host1(config)# atm bulk-config test1 vc-range 0 1 101 600
vc-range 3 5 201 3200
■
Use the no version to remove the specified VC range from the ATM AAL5
interface, to remove the specified subranges from the specified VC range, or to
remove all subranges from the specified VC range. The
no version also removes
any overriding profile assignments for ATM PVCs within the deleted VC range
or VC subrange.
■
See atm bulk-config.
atm bulk-config modify
■
Use to expand or shorten the range of the specified VC subrange. You can modify
only a single specific subrange at a time.
■
You can expand a subrange if none of the added circuits overlap with any other
subrange. You can shorten a subrange if none of the dropped circuits have
existing dynamic ATM 1483 subinterfaces.
■
Modifying a subrange so that it completely includes at least one other subrange
from within the same VC range effectively merges the subranges. Each subrange
that is merged with another frees up a subrange for subsequent configuration.
The subranges that are merged do not need to be adjacent to each other.
■
The router retains any overriding profiles assigned to a subrange if the assignment
falls within the modified subrange. If the assignment falls outside of the newly
modified subrange, the router drops the overriding profile assignment. If two
subranges are merged, the router retains overriding profiles that were assigned
to the separate subranges and applies the overriding profiles to the newly merged
subrange.
■
Example
host1(config-if)# atm bulk-config test modify vc-range 2 3 210 230
■
There is no no version.
■
See atm bulk-config modify.
atm bulk-config shutdown
■
Use to administratively disable (shut down) a specified VC subrange or all
subranges in a VC range. The administrative state of a VC subrange is enabled
by default.
■
Disabling the VC subrange deletes all dynamic ATM 1483 subinterfaces on the
affected subranges. You can use the
show atm subinterface command or the
show atm vc command to monitor the progress of the removal of all dynamic
ATM 1483 subinterfaces for the specified subrange.
Configuring ATM 1483 Dynamic Subinterfaces
■ 655
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration