Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 590 / 774

Figure 53: Dynamic Bridged Ethernet over Static ATM 1483 Interface Columns
Configuring a Dynamic Bridged Ethernet Interface
When you configure dynamic bridged Ethernet interfaces, you must assign a profile.
You may optionally assign a subscriber identification.
To configure dynamic bridged Ethernet interfaces:
1.
Configure a physical interface.
host1(config)# interface atm 5/0
2.
Configure an ATM subinterface.
host1(config-if)# interface atm 2/0.1
3.
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
If you want the router to autodetect the encapsulation type, use the
aal5autoconfig option.
host1(config-subif)# atm pvc 10 100 22 aal5snap
host1(config-subif)# atm pvc 10 100 22 aal5autoconfig
4.
Do either of the following:
■
Configure the subinterface to detect and accept the dynamic bridged Ethernet
encapsulation type with the default lockout time range, 1–300 seconds.
host1(config-subif)# auto-configure bridgedEthernet
■
Configure the subinterface to detect and accept the dynamic bridged Ethernet
encapsulation type with a nondefault lockout time range. For example, the
following command configures 3600 seconds (1 hour) as the minimum
lockout time and 7200 seconds (2 hours) as the maximum lockout time.
host1(config-subif)# auto-configure bridgedEthernet lockout-time 3600 7200
558 ■
Configuring Bridged Ethernet Dynamic Interfaces
JUNOSe 11.1.x Link Layer Configuration Guide