Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 478 / 774

■
S-VLAN oversubscription is not supported on bridged Ethernet interfaces.
After you configure the bridged Ethernet interface, you configure the VLANs, S-VLANs,
and the supported higher-level protocols in the same way that you configure them
over Ethernet interfaces.
For more information, see:
■
“Configuring VLAN and S-VLAN Subinterfaces” on page 169 for introductory
information about VLANs and S-VLANs.
■
“Configuring VLANs over Bridged Ethernet” on page 453 and “Configuring S-VLANs
over Bridged Ethernet” on page 458 for examples that illustrate VLAN and S-VLAN
configurations over bridged Ethernet.
Platform Considerations
You can configure bridged Ethernet on the following E Series Broadband Services
Routers:
■
E120 router
■
E320 router
■
ERX1440 router
■
ERX1410 router
■
ERX710 router
■
ERX705 router
■
ERX310 router
Module Requirements
For information about the modules that support bridged Ethernet on ERX14xx models,
ERX7xx models, and the ERX310 router:
■
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
■
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support bridged Ethernet.
For information about the modules that support bridged Ethernet on the E120 and
E320 routers:
■
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
■
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support bridged Ethernet.
446 ■
Platform Considerations
JUNOSe 11.1.x Link Layer Configuration Guide