Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 124 / 774

■
Use to display a summary of all configured ATM virtual circuits (VCs) and reserved
VC ranges.
■
You can specify one or more of the following keywords individually or in
combination:
■
vpi —Displays VCs on a specific VPI
■
category —Displays VCs that have a specific service category
■
status —Displays VCs with a certain status
■
You can also specify the reserved keyword with no other keywords to display
only a summary of all reserved VC ranges on the router. This includes VPI/VCI
ranges reserved for use by dynamic ATM 1483 subinterfaces and by MPLS.
■
Field descriptions
■
Interface—Interface number
■
VPI—Virtual path identifier
■
VCI—Virtual channel identifier
■
VCD—Virtual circuit descriptor
■
Type—Type of circuit: PVC
■
Encap—Encapsulation method: AUTO, AAL5, AAL0, MUX, SNAP, ILMI,
F4-OAM
■
Category—Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, or CBR
■
Rx/Tx Peak—Peak rate, in Kbps
■
Rx/Tx Avg—Average rate, in Kbps
■
Rx/Tx Burst—Maximum number of cells that can be burst at the peak cell
rate
■
Status—State of the virtual circuit: Up or Down
■
Start VPI—Starting virtual path identifier (inclusive) of the reserved VC range
■
Start VCI—Starting virtual circuit identifier (inclusive) of the reserved VC
range
■
End VPI—Ending virtual path identifier (inclusive) of the reserved VC range
■
End VCI—Ending virtual circuit identifier (inclusive) of the reserved VC range
■
Example 1—Displays all VCs and reserved VC ranges on the router
host1# show atm vc
Cate Rx/Tx Rx/Tx Rx/Tx Sta
Interface VPI VCI VCD Type Encap gory Peak Avg Burst tus
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101 4375 PVC AUTO CBR 1000 0 0 UP
ATM 3/0.3 0 102 4376 PVC AUTO CBR 1000 0 0 DOWN
...
92 ■
Monitoring ATM
JUNOSe 11.1.x Link Layer Configuration Guide