Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 196 / 774

■
Duplex Mode—Duplex option for this interface
■
Operational—Duplex option currently used
■
Administrative—Setting for duplex that you specified
■
Speed—Line speed for this interface
■
Operational—Current rate at which packets are processed
■
Administrative—Setting for line speed that you specified
■
Debounce—Debounce configuration for this interface
■
State is—Enabled, Disabled
■
Interval is—Number of seconds that this interface maintains a given
state before the state change is reported to the upper-layer links
■
Clear arp—State of the removal of the ARP entries on an interface with
redundant ports
■
Enabled—Clears ARP entries on the interface when the primary link
fails
■
Disabled—Maintains ARP entries on the interface until the specified
timeout elapses
■
Link—Link information for this interface
■
Operational Link Selected—Port that the I/O module is currently using:
primary or secondary
■
Administrative link selected—Port that the I/O module is configured to
use:
■
primary—Only primary port is configured to operate
■
secondary—Only redundant port is configured to operate
■
automatically—Software controls port redundancy automatically
■
Link Failover Timeout — Time to wait for a failed link to be active before
the router uses a different active link
■
Primary link selected x times—Number of times that the I/O has used the
primary port since the module was last rebooted
■
Secondary link selected x times—Number of times that the I/O has used the
secondary port since the module was last rebooted
■
Primary/Secondary link signal detected, Primary/Secondary link signal not
detected—Specifies the port (primary or secondary) on which the router
detects a signal
■
5 minute input rate—Data rates based on the traffic received in the last 5
minutes
■
5 minute output rate—Data rates based on the traffic sent in the last 5
minutes
164 ■
Monitoring Upper-Level Protocols over Ethernet
JUNOSe 11.1.x Link Layer Configuration Guide