Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 280 / 774

b. Alternatively, you can disable the remote loopback operation on the remote
OAM entity by instructing it to not loop back any received non-OAM PDUs
from the local OAM entity.
host1# ethernet oam lfm remote-loopback stop interface gigabitEthernet
1/0
When you halt the remote loopback operation to cause the remote peer to
not loop back any PDUs that it receives from the local entity by using the
ethernet oam lfm remote-loopback stop command, the number of frames
and bytes that are transmitted from the local entity to the remote peer when
the local interface is in loopback mode, and the number of frames and bytes
that are received from the remote peer when the remote peer is in loopback
mode are displayed using appropriate field labels at the CLI prompt. You
can also view the calculated loopback parameter values later from the Remote
Loopback section in the output of the
show ethernet oam lfm status
command.
Related Topics
■
Guidelines for Configuring 802.3ah OAM Link-Fault Management on page 242
■
ethernet oam lfm
■
ethernet oam lfm mode
■
ethernet oam lfm high-threshold
■
ethernet oam lfm link-monitor frame-seconds
■
ethernet oam lfm link-monitor frame-seconds-summary
■
ethernet oam lfm link-monitor symbol-period
■
ethernet oam lfm pdu-lost-threshold
■
ethernet oam lfm pdu-transmit-interval
■
ethernet oam lfm remote-failure
■
ethernet oam lfm remote-loopback
■
ethernet oam lfm remote-loopback supported
■
Monitoring OAM Link-Fault Management Configuration for an Interface on
page 255
■
Monitoring OAM Link-Fault Management Discovery Settings for an Interface on
page 250
■
Monitoring OAM Link-Fault Management Statistics for an Interface on page 253
■
Monitoring OAM Link-Fault Management Sessions on All Configured Interfaces
on page 258
248 ■
Configuring 802.3ah OAM Link-Fault Management
JUNOSe 11.1.x Link Layer Configuration Guide