Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 332 / 774

PPP Multilink Status
Configuration status configured notConfigured
Link Interface 8000 n/a
Network Interface 2000 n/a
Ip 2000 0
Ipv6 0 2000
Osi 0 2000
Mpls 0 2000
Administrative status open closed
Link Interface 8000 0
Network Interface 2000 0
Ip 2000 0
Ipv6 2000 0
Osi 2000 0
Mpls 2000 0
Operational status up down notPresent noResources
Link Interface 8000 0 0 n/a
Network Interface 2000 0 0 n/a
Ip 2000 0 0 0
Ipv6 0 0 2000 0
Osi 0 0 2000 0
Mpls 0 0 2000 0
Operational status lowerDown passive tunnel
Link Interface 0 0 0
Network Interface 0 0 0
■
See show ppp interface summary.
Troubleshooting
Use the pppPacket log to diagnose problems on your PPP interfaces. On dynamic
PPP interfaces, you can use the ppp log command within the profile, as described
in “Configuring Dynamic Interfaces” on page 515.
log severity debug pppPacket
■
Use to configure a trace log file for a PPP interface.
■
Specify one of the following interface types and an interface specifier . For
example, specify slot/port:channel/subchannel for a serial POS PPP interface.
■
serial—Serial interface
■
atm—ATM interface
■
pos—Packet over SONET interface
■
You also configure logging to direct the output to a specific destination. For
information, see Overview of System Logging.
■
Example
host1(config-if)# log severity debug pppPacket serial 0/0:1/1
DEBUG 01/01/1970 00:16:58 pppPacket (1000001,*): interface:0/0:1/11/0:1,
time: 0.00, tx lcp confReq, id = 226, length = 19, mru = 32759,
authentication = chap MD5,magicNumber = 0x5387f9a2
DEBUG 01/01/1970 00:16:58 pppPacket (1000001,*): interface: 0/0:1/11/0:1,
300 ■
Troubleshooting
JUNOSe 11.1.x Link Layer Configuration Guide