Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 607 / 774

ip virtual-router
■
Use to assign a virtual router (VR) to a profile. Interfaces created by the profile
are attached to this VR.
■
If the VR specified in a profile with the ip virtual-router command differs from
the VR provided by AAA, IP uses the VR provided by AAA when the dynamic IP
upper-layer interface is created. For more information about using the
ppp
authentication virtual-router command, see “ppp authentication” on page 580.
■
Example
host1(config-profile)# ip virtual-router salem1
■
Use the no version to remove the VR assignment from the profile. If no VR is
specified via RADIUS, then any subsequent use of the profile to create a dynamic
interface fails for lack of a VR.
■
See ip virtual-router
ipv6 address
■
Use to configure an IPv6 address on an interface to which the profile is attached.
■
Example
host1(config-profile)# ipv6 address 1::1/64
■
Use the no version to remove the IPv6 address from the interface.
■
See ipv6 address.
ipv6 http
■
Use to create the HTTP local server to listen and process for IPv6 exception
packets.
■
See Configuring the HTTP Server to Support Guided Entrance in the JUNOSe
Broadband Access Configuration Guide
■
Example
host1(config)# ipv6 http
■
Use the no version to delete the HTTP local server.
■
See ipv6 http.
ipv6 http redirectUrl
■
Use to specify the URL to which a subscriber’s HTTP access session is redirected.
■
The first access session is typically used by the Service Manager application to
provide initial provisioning and service selection for the subscriber.
■
HTTP redirect is per-interface; use the command in Interface, Subinterface or
Profile Configuration mode for static interfaces.
■
The redirect URL can be a maximum of 64 characters.
Configuring a Dynamic Interface from a Profile
■ 575
Chapter 17: Configuring Dynamic Interfaces