Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 620 / 774

ppp peer
■
Use to resolve conflicts when the router and the PPP peer system have the
primary and secondary DNS and WINS addresses configured with different
values.
■
By default, the DNS and WINS addresses configured on the router take
precedence.
■
Use the ppp peer dns command or the ppp peer wins command to configure
the PPP peer system as the one that takes precedence. The ppp peer command
has no effect unless both systems have the address configured and the address
is in conflict. If the PPP peer system has the address and the router does not,
the peer always supplies the address regardless of how you have configured the
PPP peer.
■
Example
host1(config-profile)# ppp peer dns
■
Use the no ppp peer dns command or the no ppp peer wins command when
you want the router to take precedence during setup negotiations between the
router and the remote PC client. If the IP addresses passed to the router by the
remote PC client differ from the ones you have configured on your router, the
router returns the values that you configured as the correct values to the remote
PC client.
■
See ppp peer.
ppp reassembly
■
Use to enable reassembly on an MLPPP link interface and optionally specify the
administrative MRRU value, in octets, for the link.
■
Example
host1(config-profile)# ppp reassembly 1590
■
Use the no version to disable reassembly on the link and restore the default
value, which is the link’s local MRU.
■
See ppp reassembly.
pppoe acName
■
Use to add an access concentrator (AC) name to the profile configuration.
■
Example
host1(config-profile)# pppoe acName CYM9876
■
Use the no version to remove the AC name.
■
See pppoe acName.
pppoe always-offer
588 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide