Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 149 / 774

NOTE: Before you configure Frame Relay, see the appropriate chapter in this guide
for details on configuring physical interfaces.
■
slot —Router chassis slot
■
port —CT3, T3, or E3 module I/O port
■
channel —T1 (DS1) channel
■
subchannel —Set of DS0 timeslots. See section Fractional T1 in JUNOSe
Physical Layer Configuration Guide
■
subinterface —User-assigned nonnegative number that identifies a Frame
Relay subinterface
■
Example
host1(config-if)# interface serial 3/1:2/1.1
■
Use the no version to remove the subinterface or the serial interface.
■
See interface serial.
ip address
■
Use to assign an IP address and subnet mask to a subinterface.
■
Example
host1(config-subif)# ip address 192.32.10.2 255.255.255.0
■
Use the no version to remove an IP address or to disable IP processing.
■
See ip address.
pos description
■
Use to assign a text description or an alias to a POS HDLC interface.
■
You can use this command to help you identify the interface and keep track of
interface connections.
■
The description or alias can be a maximum of 80 characters.
■
Use “show interfaces pos” on page 371 to display the text description. For details,
see “Monitoring POS” on page 371 in “Configuring Packet over SONET” on
page 363.
■
Example
host1(config-if)# pos description austin01 pos interface
■
Use the no version to remove the text description or alias.
■
See pos description.
serial description
Configuring Frame Relay
■ 117
Chapter 2: Configuring Frame Relay