Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 211 / 774

encapsulation vlan
■
Use to configure VLAN as the encapsulation method for the interface.
■
Example
host1(config-if)# encapsulation vlan
■
Use the no version to disable VLAN on an interface.
■
See encapsulation vlan.
ip address
■
Use to set a primary or secondary IP address for an interface or subinterface.
■
Specify the layer 2 encapsulation before you set the IP address.
■
Example
host1(config-if)# ip address 192.6.129.5 255.255.255.0
■
Use the no version to remove an IP address or disable IP processing.
■
See ip address.
pppoe
■
Use to configure PPPoE as the encapsulation method on the interface.
■
Example
host1(config-if)# pppoe
■
Use the no version to disable PPPoE on the interface.
■
See pppoe.
pppoe subinterface fastEthernet
■
Use to create a PPPoE subinterface on a Fast Ethernet interface.
■
Example
host1(config-if)# pppoe subinterface fastEthernet 4/1.1.1
■
Use the no version to remove a PPPoE subinterface on a Fast Ethernet interface.
■
See pppoe subinterface.
pppoe subinterface gigabitEthernet
pppoe subinterface tenGigabitEthernet
■
Use to create a PPPoE subinterface on a Gigabit Ethernet interface or on a
10-Gigabit Ethernet interface.
■
Example 1—Creates a PPPoE subinterface on an ERX7xx model, ERX14xx model,
or the ERX310 router
Creating a VLAN Subinterface
■ 179
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces