Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 707 / 774

■
Example 1—Assigns an overriding profile (test1OverridingProfile) to the dynamic
VLAN subinterface with VLAN ID 202
host1(config-if)# profile vlan override bulk-config vlan 202 test1OverridingProfile
■
Example 2—Assigns an overriding profile (test1DebugProfile) to the S-VLAN
subinterface with S-VLAN ID 100 within the VLAN subinterface with V-LAN ID
202
host1(config-if)# profile vlan override bulk-config svlan 100 202
test1OverridingProfile
■
Example 3—Removes the overriding profile assignment from the VLAN
subinterface with VLAN ID 202, and restores the original base profile assignment
host1(config-if)# no profile vlan override bulk-config vlan 202
test1OverridingProfile
■
Use the no version to remove the overriding profile assignment for the VLAN ID
or S-VLAN ID and restore the original base profile assignment.
■
See profile vlan override bulk-config.
shutdown
■
Use to disable an interface.
■
When you disable a dynamic VLAN subinterface, the shutdown command deletes
the VLAN dynamic subinterface column and removes the dynamic VLAN
subinterface.
■
Example
host1(config-subif)# shutdown
■
Because the shutdown command removes the dynamic VLAN subinterface from
the router, issuing a subsequent no version of this command has no effect; that
is, it does not restart the disabled subinterface.
■
See shutdown.
svlan ethertype
■
Use to specify the available Ethertypes that a packet must use to create a dynamic
VLAN subinterface.
■
Choose one of the following Ethertype values:
■
8100 —Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
■
88a8 —Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard
802.1ad
■
9100 —Specifies Ethertype value 0x9100
■
autoconfig —Specifies that the packet can use any Ethertype to create a
dynamic VLAN subinterface
■
Examples
Configuring VLAN Dynamic Subinterfaces
■ 675
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration