Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 215 / 774

Use to configure PPP as the encapsulation method for the interface.
■
■
Use the no version to remove PPP as the encapsulation method on the interface.
■
See encapsulation ppp.
encapsulation vlan
Use to configure VLAN as the encapsulation method for the interface.
■
■
Use the no version to remove VLAN as the encapsulation method on the interface.
■
See encapsulation vlan.
ip address
■
Use to set a primary or secondary IP address for an interface or subinterface.
■
Specify the layer 2 encapsulation before you set the IP address.
■
Use the no version to remove an IP address or disable IP processing.
■
See ip address.
pppoe
Use to configure PPPoE as the encapsulation method on the interface.
■
■
Use the no version to disable PPPoE on the interface.
■
See pppoe.
pppoe subinterface fastEthernet
Use to create a PPPoE subinterface on a Fast Ethernet interface.
■
■
Use the no version to remove a PPPoE subinterface on a Fast Ethernet interface.
■
See pppoe subinterface.
pppoe subinterface gigabitEthernet
pppoe subinterface tenGigabitEthernet
Use to create a PPPoE subinterface on a Gigabit Ethernet interface or on a
10-Gigabit Ethernet interface.
■
■
Use the no version to remove a PPPoE subinterface on a Gigabit Ethernet interface
or on a 10-Gigabit Ethernet interface.
■
See pppoe subinterface.
svlan ethertype
■
Use to assign an Ethertype value for the S-VLAN subinterface.
■
Choose one of the following Ethertype values:
■
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
■
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard
802.1ad
Configuring an S-VLAN Subinterface
■ 183
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces