Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 62 / 774

■
Use to generate ILMI keepalive messages. This value sets the time interval in
seconds between poll PDU transmissions if no sequence data PDUs are pending.
■
Example
host1(config-if)# atm ilmi-keepalive 5
■
Use the no version to disable the generation of keepalive messages.
■
See atm ilmi-keepalive.
atm lbo
■
Use to specify the cable length (line build-out) for the ATM T3 or E3 interface.
The length of cable determines power requirements.
■
Specify one of the following keywords:
■
long—A cable length in the range 0–225 feet
■
short—A cable length in the range 226–450 feet (the default)
■
Example
host1(config-if)# atm lbo long
■
Use the no version to restore the default value, short .
■
See atm lbo.
atm shutdown
■
Use to set an ATM interface administrative state to disabled.
■
When you set the administrative state of the ATM interface to disabled, the router
automatically disables all F5 OAM services configured on the associated VC, and
prevents the VC from receiving or transmitting F5 OAM cells.
■
Example
host1(config-if)# atm shutdown
■
Use the no version to enable a disabled interface.
■
See atm shutdown.
atm snmp trap link-status
■
Use to enable SNMP link status traps on the ATM layer interface.
■
Example
host1(config-if)# atm snmp trap link-status
■
Use the no version to disable the traps.
■
See atm snmp trap link-status.
atm sonet stm-1
30 ■
Setting Optional Parameters
JUNOSe 11.1.x Link Layer Configuration Guide