Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 354 / 774

■
If you issue the command in the context of an encapsulated MLPPP interface, it
affects only that interface. If you issue the command in the context of an MLPPP
bundle, it affects all member links within that bundle.
■
Example
host1(config-if)# ppp mru 576
■
Use the no version to restore the default value, which causes PPP to use the
lower-layer MRU minus the PPP header length as the MRU value.
■
See ppp mru.
ppp passive-mode
■
Use to force a static or dynamic PPP interface into passive mode, for a period
of one second, before LCP negotiation begins. This delay enables slow clients to
start up and initiate the LCP negotiation.
■
Example
host1(config-if)# ppp passive-mode
■
Use the no version to disable passive mode.
■
See ppp passive-mode.
ppp peer
■
Use to resolve conflicts when the system and the PPP peer system have primary
and secondary DNS and WINS addresses configured with different values.
■
By default, the DNS and WINS addresses configured on the system take
precedence.
■
Use the ppp peer dns or the ppp peer wins commands to configure the PPP
peer system as the one that takes precedence. This command has no effect
unless both systems have the address configured and the address is in conflict.
If the PPP peer system has the address and the system does not, the peer always
supplies the address regardless of how you have configured the PPP peer.
■
Example
host1(config-profile)# ppp peer dns
■
Use the no ppp peer dns or the no ppp peer wins commands when you want
the system to take precedence during setup negotiations between the system
and the remote PC client. If the IP addresses passed to the system by the remote
PC client differ from the ones you have configured on your system, the system
returns the values that you configured as the correct values to the remote PC
client.
■
See ppp peer.
ppp shutdown
322 ■
Configuring Static MLPPP
JUNOSe 11.1.x Link Layer Configuration Guide