Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 238 / 774

■
Use the no version to restore the default behavior.
■
See lacp.
lacp port-priority
■
Use to set the priority for an Ethernet link in a LAG bundle.
■
The member with the lowest value has the highest priority, and is selected to
join the LAG bundle first.
■
Valid values are in the range 0–65535.
■
Example
host1(config-if)# lacp port-priority 100
■
Use the no version to restore the default value of 32768.
■
See lacp port-priority.
member-interface
■
Use to add a Fast Ethernet interface or Gigabit Ethernet interface, also known
as a bundle member, to a LAG bundle.
■
Example
host1(config-if)# member-interface fastEthernet 4/0
■
Use the no version to remove the specified Ethernet link from the bundle.
■
See member-interface.
minimum-links
■
Use to configure the minimum number of member links in the link aggregation
group (LAG) bundle for the LAG interface to be considered up. The minimum
number of member links that you can configure, depends on the IOA. For
example, for ES2–S1 GE-4 IOA, the number of minimum links is in the range
0–4. For ES2–S1 GE-8 IOA, the number of minimum links is in the range 0–8
and for ES2–S3 GE-20 IOA, the number of minimum links is in the range 0–8.
■
Example
host1(config-if)# minimum—links 2
■
Use the no version to reset the minimum number of member links to the default
value, 1.
■
See minimum-links
mpls
■
Use to enable, disable, or delete MPLS on an interface. MPLS is disabled by
default.
■
Example
host1(config)# mpls
206 ■
Configuring 802.3ad Link Aggregation
JUNOSe 11.1.x Link Layer Configuration Guide