Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 688 / 774

■
No dynamic ATM 1483 subinterfaces can subsequently be created for the
subrange until you restore the administrative state to enabled by using the
no
atm bulk-config shutdown command.
■
Example
host1(config-if)# atm bulk-config test shutdown vc-range 2 2 201 250
■
Use the no version to enable the specified VC subrange or all subranges in a VC
range.
■
See atm bulk-config shutdown.
Configuring Static ATM Interfaces Within VC Subranges
You can do either of the following on an E Series router:
■
Create a static ATM interface within an existing bulk-configured VC subrange
■
Create a bulk-configured VC subrange that includes an existing static ATM
interface
The following sections describe how to perform these tasks.
Creating Static ATM Interfaces Within VC Subranges
You can configure a static ATM interface with an ATM PVC whose VPI and VCI
addresses fall within an existing bulk-configured VC subrange.
To create a static ATM interface within a VC subrange:
1.
Create a bulk-configured VC range that includes one or more VC subranges.
host1(config)# interface atm 0/0
host1(config-if)# atm bulk-config test vc-range 1 3 32 1031
2.
Specify a static ATM 1483 subinterface.
host1(config-if)# interface atm 0/0.2100
3.
Configure an ATM PVC with VPI and VCI values that fall within the bulk-configured
VC subrange. In this example, the VPI value (2) is within the VPI range 1–3, and
the VCI value (100) is within the VCI range 32–1031.
host1(config-subif)# atm pvc 2100 2 100 aal0
4.
Configure the static ATM interface. For example, the mpls-relay command
creates a ATM layer 2 services over MPLS tunnel on the circuit.
host1(config-subif)# mpls-relay 192.168.0.1 2100
656 ■
Configuring ATM 1483 Dynamic Subinterfaces
JUNOSe 11.1.x Link Layer Configuration Guide