Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 708 / 774

host1(config-profile)# svlan ethertype 8100
host1(config-profile)# svlan ethertype autoconfig
■
Use the no version to restore the default value, autoconfig.
■
See svlan ethertype.
vlan advisory-rx-speed
■
Use to set an advisory receive speed for VLAN subinterfaces that are created
with the profile you are configuring. This setting has no effect on data forwarding.
You can use it to indicate the speed of the client interface. When traffic is tunneled
with L2TP, the advisory receive speed is sent from the LAC to the LNS. See LAC
Configuration Prerequisites for additional information about the advisory receive
speed.
■
The range is 0–2147483647 kbps; 0 indicates no advisory speed setting.
■
Example
host1(config-profile)# vlan advisory-rx-speed 2000
■
Use the no version to restore the default behavior—the Rx speed is not sent to
the LNS.
■
See vlan advisory-rx-speed
vlan advisory-tx-speed
■
Use to set an advisory connect speed for VLAN subinterfaces that are created
with the profile that you are configuring. This setting has no effect on data
forwarding. You can use it to indicate the speed of the client interface. When
traffic is tunneled with L2TP, the advisory receive speed is sent from the LAC to
the LNS. See LAC Configuration Prerequisites for additional information about
the advisory receive speed.
■
The range is 0–2147483647 kbps; 0 indicates no advisory speed setting.
■
Example
host1(config-profile)# vlan advisory-tx-speed 2000
■
Use the no version to restore the default behavior—the Tx speed is not sent to
the LNS.
■
See vlan advisory-tx-speed.
vlan auto-configure
■
Use to specify the types of dynamic upper-interface encapsulations that are
accepted or detected by a dynamic VLAN subinterface.
■
Include this command in the base profile for a dynamic VLAN subinterface.
■
Use the lockout-time keyword to specify the minimum and maximum lockout
time range for the encapsulation type. For more information, see “Encapsulation
Type Lockout” on page 525.
■
Example
676 ■
Configuring VLAN Dynamic Subinterfaces
JUNOSe 11.1.x Link Layer Configuration Guide