Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 706 / 774

■
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
■
See interface gigabitEthernet.
■
See interface tenGigabitEthernet.
profile
■
Use to create a base profile to configure attributes for a dynamic VLAN
subinterface.
■
Specify a profile name of up to 80 alphanumeric characters.
■
Example
host1(config)# profile vlanBaseProfile
■
Use the no version to delete the specified profile.
■
See profile/
profile vlan bulk-config
■
Use to assign the base profile configured for a dynamic VLAN subinterface to
the single-tagged VLAN IDs or double-tagged S-VLAN IDs configured on a static
VLAN major interface.
■
You must specify both of the following:
■
Name assigned to the VLAN range on a VLAN subinterface, as specified in
“vlan bulk-config” on page 685
■
Name assigned to the base profile for a dynamic VLAN subinterface
■
Example
host1(config-if)# profile vlan bulk-config myBulkConfig vlanBaseProfile
■
Use the no version to remove the base profile assignment.
■
See profile vlan bulk-config.
profile vlan override bulk-config
■
Use to assign an overriding profile to a single VLAN ID or double-tagged S-VLAN
ID.
■
Using an overriding profile enables you to assign a special profile for the
subscribers associated with a specific DSLAM.
■
You can also use an overriding profile to troubleshoot the specified VLAN or
S-VLAN by overriding the currently assigned base profile with one that has
debugging attributes enabled.
■
Use the any keyword to specify a VLAN ID as a wildcard. When you specify the
any keyword with an S-VLAN ID of a DSLAM, all subscribers associated with the
DSLAM will be created with the same profile.
674 ■
Configuring VLAN Dynamic Subinterfaces
JUNOSe 11.1.x Link Layer Configuration Guide