Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 401 / 774

■
Use the no version to remove the POS interface.
■
See interface pos.
load-interval
■
Use to set the time interval at which the router calculates bit and packet rate
counters.
■
You can choose a multiple of 30 seconds, in the range 30–300 seconds.
■
Example
host1(config-if)# load-interval 90
■
Use the no version to restore the default value, 300.
■
See load-interval.
loopback
Use to specify the type of loopback for a POS interface.
■
■
internal —Connects the local transmitted signal to the local received signal.
■
line —Connects the received network signal directly to the transmit network
signal. When configured in line loopback mode, the router never receives
data from the network.
■
Example
host1(config-if)# loopback line
■
Use the no version to clear the loopback.
■
See loopback.
mru
■
Use to set the maximum allowable size of the MRU.
■
Specify a value in the range 1–9996 bytes.
■
Example
host1(config-if)# mru 1000
■
Use the no version to restore the default value, 4470.
■
See mru.
mtu
■
Use to set the maximum allowable size of the MTU.
■
Specify a value in the range 1–9996 bytes.
■
Example
host1(config-if)# mtu 1000
Configuration Tasks
■ 369
Chapter 11: Configuring Packet over SONET