Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 54 / 774

Configuration Tasks
The following sections describe how to perform these ATM configuration tasks:
Creating a Basic Configuration
To configure ATM, perform the following tasks. (Figure 3 on page 23 shows the
relationship of Steps 1 through 3.)
1.
Configure an ATM physical interface.
host1(config)# interface atm 0/1
2.
Configure an ATM 1483 subinterface.
host1(config-if)# interface atm 0/1.20
3.
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
host1(config-subif)# atm pvc 10 15 22 aal5snap
4.
Assign an IP address and subnet mask to the PVC.
host1(config-subif)# ip address 192.32.10.20 255.255.255.0
5.
(Optional) Verify your configuration using the appropriate show commands.
host1# show atm interface atm 0/1
host1# show atm vc atm 0/1 10
host1# show atm subinterface atm 0/1.20
22 ■
Configuration Tasks
JUNOSe 11.1.x Link Layer Configuration Guide