Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 709 / 774

host1(config-profile)# vlan auto-configure ip
■
Use the no version to terminate detection of the specified encapsulation type.
■
See vlan auto-configure.
vlan auto-configure agent-circuit-identifier
■
Use to create a VLAN subinterface that is based on the agent-circuit-id information
in the option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE
PADR and PADI packets.
■
Include this command in the base profile for a dynamic VLAN subinterface.
■
Example
host1(config-profile)# vlan auto-configure agent-circuit-identifier
■
Use the no version to disable creation of VLAN subinterfaces based on
agent-circuit-identifier information.
■
See vlan auto-configure agent-circuit-identifier.
vlan bulk-config
■
Use to create a bulk-configured VLAN range on a static VLAN major interface for
use by a dynamic VLAN subinterface.
NOTE: For information about the maximum number of VLAN bulk configurations
supported per chassis, see JUNOSe Release Notes , Appendix A , System Maximums .
■
Each VLAN range consists of one or more nonoverlapping VLAN subranges. A
VLAN subrange is a group of VLAN IDs or S-VLAN IDs that reside within the VLAN
range you specify.
■
You can configure multiple VLAN ranges on a VLAN subinterface.
■
When you create a bulk-configured VLAN range, you must specify the following:
■
A name of up to 80 alphanumeric characters; this is also referred to as the
bulk configuration name
■
The starting and ending VLAN ID or S-VLAN ID values (inclusive) for each
VLAN subrange
■
Use the any keyword to specify a VLAN ID as a wildcard. When you specify the
any keyword with an S-VLAN ID of a DSLAM, all subscribers associated with the
DSLAM will be created with the same profile.
■
Use the agent-circuit-identifier keyword to configure a VLAN range that is based
on the agent-circuit-id information in the option 82 field of DHCP messages or
in the DSL Forum VSA 26-1 of PPPoE PADR and PADI packets. When you specify
the
agent-circuit-identifier keyword with an S-VLAN ID of a DSLAM, all
subscribers associated with the DSLAM are created with the same profile.
Configuring VLAN Dynamic Subinterfaces
■ 677
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration