Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 603 / 774

Use the no version with the exclude-primary keyword to specify that the primary
interface is assigned to a subscriber.
■
See ip auto-configure ip-subscriber.
ip auto-detect ip-subscriber
■
Use to enable packet detection on the router and specify that IP automatically
detect packets that do not match any entries in the demultiplexer table.
■
Example
host1(config-profile)# ip auto-detect ip-subscriber
■
Use the no version to restore the default behavior, which disables packet
detection.
■
See ip auto-detect ip-subscriber.
ip directed-broadcast
■
Use to enable a directed broadcast address in a profile.
■
Example
host1(config-profile)# ip directed-broadcast
■
Use the no version to remove the directed broadcast address from the profile.
■
See ip directed-broadcast.
ip filter-options all
■
Use to filter out packets that include IP options.
■
Example
host1(config-profile)# ip filter-options all
■
Use the no version to disable filtering of packets with IP options.
■
See ip filter-options all.
ip igmp
■
Use to enable IGMP on an interface, and sets the IGMP version to IGMPv2.
■
Example
host1(config-profile)# ip igmp
■
Use the no version to disable IGMP on an interface.
■
See ip igmp.
ip ignore-df-bit
Configuring a Dynamic Interface from a Profile
■ 571
Chapter 17: Configuring Dynamic Interfaces