Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 184 / 774

In bytes: 512 Out bytes: 0
In frames: 16 Out frames: 0
In errors: 0 Out errors: 0
In discards: 16 Out discards: 0
In unknown protos: 0
Frame relay sub-interface mlframe-relayTEST.2, status is up
Number of sub-interface down transitions is 0
Time since last status change 00:07:50
In bytes: 512 Out bytes: 0
In frames: 16 Out frames: 0
In errors: 0 Out errors: 0
In discards: 16 Out discards: 0
In unknown protos: 0
■
See show frame-relay subinterface.
show frame-relay summary
■
Use to scan all defined Frame Relay interfaces and circuits and to report the
status for each discovered interface and circuit as follows:
■
Up — Traffic can flow on the interface
■
Down — Traffic cannot flow because of a problem in the network
■
Unavailable—Traffic cannot flow because hardware is unavailable
■
Example
host1# show frame-relay summary
2 multilink interface(s) defined, 2 up, 0 down
1 interface(s) defined, 1 up, 0 down
2 sub-interface(s) defined, 2 up, 0 down
2 circuit(s) defined, 2 up, 0 down
■
See show frame-relay summary.
152 ■
Monitoring MLFR
JUNOSe 11.1.x Link Layer Configuration Guide