Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 600 / 774

■
advisory-rx-speed—Sets an advisory receive speed for VLAN subinterfaces
■
advisory-tx-speed—Sets an advisory connect speed for VLAN subinterfaces
■
auto-configure—Specifies the types of upper-interface encapsulations that are
accepted or detected by the dynamic VLAN subinterface
■
auto-configure agent-circuit-identifier—Enables the creation of VLAN subinterfaces
that are based on agent-circuit-identifier information
■
description—Assigns a description to VLAN subinterfaces that are created with
this profile
■
policy—Attaches (or removes) a policy to (or from) a dynamically created VLAN
■
profile—Adds a nested profile assignment, which references another profile that
dynamically configures an upper-interface encapsulation type over the VLAN
subinterface
■
service-profile—Specifies a service profile name to a dynamically created VLAN
■
svlan ethertype—Specifies that the packet must use this Ethertype to create the
dynamic VLAN subinterface
Working with Profiles
Figure 54 on page 568 shows how to create a profile and assign characteristics to it.
Figure 54: Creating and Configuring a Profile
Figure 55 on page 569 shows how to assign a profile to static interfaces. These static
interfaces create dynamic interfaces above them.
568 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide