Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 628 / 774

■
Use to configure an ATM subinterface to support a dynamic interface. Specifies
one or more types of dynamic encapsulation that the ATM 1483 subinterface
detects and accepts.
■
For detailed information about how to use this command, see “auto-configure”
on page 531.
■
Example 1—Enables autodetection for the bridged Ethernet encapsulation type
using the default lockout time range, 1–300 seconds
host1(config-subif)# auto-configure bridgedEthernet
■
Example 2—Enables autodetection for the bridged Ethernet encapsulation type
using a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
host1(config-subif)# auto-configure bridgedEthernet lockout-time 3600 21600
■
Example 3—Disables encapsulation type lockout for the IP encapsulation type
host1(config-subif)# auto-configure ip lockout-time none
■
Example 4—Either command reenables encapsulation type lockout for the IP
encapsulation type using the default lockout time range
host1(config-subif)# auto-configure ip
host1(config-subif)# no auto-configure ip lockout-time
■
Example 5—Permanently locks out the PPP encapsulation type until the
auto-configure ppp command is issued
host1(config-subif)# no auto-configure ppp
■
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
■
See auto-configure.
profile
■
Use to assign a profile to a static ATM 1483 or static PPP interface. The profile
configuration is used to dynamically configure an upper bridged Ethernet, IP,
PPP, or PPPoE interface.
■
The default encapsulation type, any , applies to any autoconfigured encapsulation
that does not have a specific profile assignment.
■
Example
host1(config-subif)# profile ip holland
■
Use the no version to remove the profile assignment from the interface.
■
See profile,
subscriber
596 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide