Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 608 / 774

NOTE: The HTTP local server must be configured and enabled in the virtual router
for the interface on which you use the ipv6 http redirectUrl command. Otherwise,
the URL redirect operation will fail.
■
See Configuring the HTTP Server to Support Guided Entrance in the JUNOSe
Broadband Access Configuration Guide
■
Example
host1(config-if)# ipv6 http redirectUrl http://ispsite.redirect.com
■
Use the no version to restore the default, which disables the HTTP redirect
feature.
■
See ipv6 http redirectUrl.
ipv6 mld
■
Use to enable MLD on an interface, and set the MLD version to MLDv2.
■
Example
host1(config-profile)# ipv6 mld
■
Use the no version to disable MLD on an interface.
■
See ipv6 mld.
ipv6 mtu
■
Use to set the maximum transmission unit size of IPv6 packets sent on an
interface.
■
Example
host1(config-profile)# ipv6 mtu 1000
■
Use the no version to restore the default value, 0, which means that the router
takes the value from a lower protocol layer.
■
See ipv6 mtu.
ipv6 nd
■
Use to enable the IPv6 Neighbor Discovery process on an interface.
■
Example
host1(config-profile)# ipv6 nd
■
Use the no version to disable the Neighbor Discovery process.
■
See ipv6 nd.
ipv6 nd managed-config-flag
576 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide