Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 432 / 774

■
Use to specify PPPoE as the encapsulation method for the interface.
■
This command creates a PPPoE major interface.
■
Example
host1(config-if)# pppoe
■
Use the no version to remove the PPPoE major interface.
■
See pppoe.
pppoe acName
■
Use to configure an access concentrator (AC) name on the PPPoE interface. When
the AC (the server) receives a PPPoE Active Discovery Initiation (PADI) packet
that it can serve, it replies by sending a PPPoE Active Discovery Offer (PADO)
packet. The PADO packet contains the AC name configured using this command.
■
If the AC name is not configured, the router name is used.
■
The AC name can be a maximum of 64 characters.
■
Example
host1(config-subif)# pppoe acName CYM9876
■
Use the no version to remove the AC name.
■
See pppoe acName.
pppoe duplicate-protection
■
Use to prevent a client from establishing more than one session using the same
MAC address.
■
This feature is disabled by default.
■
Example
host1(config-subif)# pppoe duplicate-protection
■
Use the no version to disable duplicate protection.
■
See pppoe duplicate-protection.
pppoe subinterface fastEthernet
■
Use to create a PPPoE subinterface on a Fast Ethernet module.
■
On ERX7xx models, ERX14xx models, and the ERX310 router, use the
slot / port / pppoeSubinterface format.
■
Example
host1(config)# pppoe subinterface fastEthernet 4/1.1
■
Use the no version to remove the PPPoE subinterface.
■
See pppoe subinterface.
400 ■
Configuring PPPoE for Ethernet Modules
JUNOSe 11.1.x Link Layer Configuration Guide