Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 321 / 774

■
max-negotiations—Maximum number of renegotiation attempts that
the router accepts before terminating a PPP session
■
ipcp prompt-option dns—Prompts the CPE (Customer Premises
Equipment) to negotiate the IPCP primary and secondary DNS options
that are locally available with the broadband remote access server
(enabled or disabled)
■
IPV6CP protocol configuration
■
configured—IPv6CP is configured on this interface (true or false)
■
administrative-status—IPv6CP administrative status (open or closed)
■
ipv6-interfaceId—Address to be used for negotiation of local IPv6 address
option
■
IPCP protocol status
■
operational-status—IPCP operational status (up, down, not present, or
not present no resources)
■
terminate-reason—Reason for termination of IPCP service
■
IPV6CP protocol status
■
operational-status—IPv6CP operational status (up, down, not present,
or not present no resources)
■
terminate-reason—Reason for termination of IPv6CP service
■
IPCP negotiated options—Shows the following negotiated addresses for the
local and remote (peer) side of the link
■
ip-address—IP address
■
ip-address-mask—IP address mask
■
primary-dns-address—Primary DNS address
■
secondary-dns-address—Secondary DNS address
■
primary-wins-address—Primary WINS address
■
secondary-wins-address—Secondary WINS address
NOTE: The command displays a value of “none” for any negotiated option parameters
if the option was not negotiated.
■
OSINLCP protocol configuration
■
configured—OSINLCP is configured on this interface (true or false)
■
administrative-status—OSINLCP administrative status (open or closed)
■
OSINLCP protocol status
Monitoring PPP Interfaces
■ 289
Chapter 8: Configuring Point-to-Point Protocol