Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 641 / 774

■
Elapsed—Time elapsed into the lockout time, in seconds; displays 0 (zero)
if the PPPoE client is not undergoing lockout
■
Next—Lockout time that the router uses for the next lockout event, in seconds
■
Example
host1# show pppoe interface atm 3/0.101 lockout-time
PPPoE interface ATM 3/0.101
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockout: 0
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a10.165e 0 0 5
■
See show pppoe interface lockout-time.
show pppoe subinterface
■
Use to display the source MAC address of a PPPoE client when a subscriber is
connected to the router through an available PPPoE session. You can then specify
this MAC address in “pppoe clear lockout interface” on page 552 to clear the
lockout condition for the PPPoE client.
■
To display configuration, status, and statistics information, including the source
MAC address of the PPPoE client, use the
full keyword.
■
The following field descriptions and example include only the portion of the
show pppoe subinterface command display relevant to the source MAC address
for PPPoE clients. For more information about using this command, see “show
pppoe subinterface” on page 428 in “Configuring Point-to-Point Protocol over
Ethernet” on page 375.
■
Field descriptions
■
PPPoE subinterface—Specifier for the PPPoE subinterface
■
source MAC address—MAC address of the PPPoE client associated with the
dynamic PPPoE subinterface column
■
Example
host1# show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
■
See show pppoe subinterface.
show profile
■
Use to display information about profiles.
■
To display information about a specific profile, use the name keyword.
■
To display a list of profiles configured on the router, use the brief keyword.
■
Field descriptions
Monitoring Upper-Layer Dynamic Interfaces and Profiles
■ 609
Chapter 17: Configuring Dynamic Interfaces