Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 621 / 774

■
Use to set up the router to offer to set up a session for the client, even if the
router has insufficient resources to establish a session.
■
This feature is disabled by default.
■
Example
host1(config-profile)# pppoe always-offer
■
Use the no version to disable this feature.
■
See pppoe always-offer.
pppoe duplicate-protection
■
Use to prevent a client from establishing more than one session using the same
MAC address.
■
This feature is disabled by default.
■
Example
host1(config-profile)# pppoe duplicate-protection
■
Use the no version to disable duplicate protection.
■
See pppoe duplicate-protection
pppoe log pppoeControlPacket
■
Use to enable packet trace logging on PPPoE dynamic interfaces created with
this profile. Packet trace information is logged to the pppoeControlPacket log.
■
Example
host1(config-profile)# pppoe log pppoeControlPacket
■
Use the no version to turn off packet trace logging.
■
See pppoe log pppoeControlPacket.
pppoe mtu
■
Use to cause the PPPoE application to send the string to the new client created
when the profile is dynamically attached to an IP interface.
■
The message string is saved in nonvolatile storage (NVS).
■
Example
host1(config-profile)# pppoe motm string
■
Use the no version to disable the command.
■
See pppoe motm.
pppoe mtu
Configuring a Dynamic Interface from a Profile
■ 589
Chapter 17: Configuring Dynamic Interfaces