Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 542 / 774

■
Use to terminate a Cisco HDLC session.
■
This command administratively disables the interface.
■
Example
host1(config-if)# hdlc shutdown
■
Use the no version to restart a disabled session. The default for each hdlc
shutdown command is the no version.
■
See hdlc shutdown.
Configuration Example
This example shows how to configure Cisco HDLC over an unchannelized DS3
interface on a cOCx/STMx line module. The example shows the complete configuration
procedure, from configuring the SONET interface to assigning an IP address to the
Cisco HDLC interface.
1.
Create or select a virtual router, vr1.
host1(config)# virtual-router vr1
2.
Configure SONET controller, slot 13, port 0.
host1:vr1(config)# controller sonet 13/0
3.
Set the SONET clock source to internal.
host1:vr1(config-controll)# clock source internal module
4.
Create an OC1 path.
host1:vr1(config-controll)# path 1 oc1 1
5.
Create an unchannelized DS3 interface.
host1:vr1(config-controll)# path 1 ds3 1 unchannelized
6.
Set the DS3 interface clock source to internal.
host1:vr1(config-controll)# path 1 ds3 1 clock source internal module
7.
Exit Controller Configuration mode.
host1:vr1(config-controll)# exit
8.
Create or select a serial interface over the DS3 interface.
host1:vr1(config)# interface serial 13/0:1/1
9.
Set the encapsulation to Cisco HDLC.
host1:vr1(config-if)# encapsulation hdlc
10.
Enable loopback detection on the interface.
510 ■
Configuration Tasks
JUNOSe 11.1.x Link Layer Configuration Guide