Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 522 / 774

5.
Assign a unique VLAN ID to the VLAN subinterface.
host1(config-if)# vlan id 100
6.
Configure a subscriber (client) bridge group interface over the VLAN subinterface.
Assign the interface to the bridge group you created in Step 1.
host1(config-subif)# bridge-group westford02
7.
Exit Subinterface Configuration mode.
host1(config-subif)# exit
8.
(Optional) Configure additional VLAN subinterfaces and bridge group interfaces
by repeating Steps 4 through 6, supplying unique values.
Monitoring Transparent Bridging
This section describes how to:
■
Set a statistics baseline for bridge groups and bridge interfaces.
■
Remove all dynamic MAC address entries or a specific dynamic MAC address
entry from the forwarding table for bridge groups and bridge interfaces.
■
Use the show commands to monitor bridge groups, bridge group interfaces, and
subscriber policies
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(
slot / adapter / port ).
490 ■
Monitoring Transparent Bridging
JUNOSe 11.1.x Link Layer Configuration Guide