Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 644 / 774

■
PPPoE Always-offer—Router offers to set up a session for the client, even if
the router has insufficient resources to establish a session; enabled or disabled
■
PPPoE Remote-Circuit-Id—The router captures and processes a
vendor-specific tag containing a remote circuit ID transmitted from a digital
subscriber line access multiplexer (DSLAM); enabled or disabled
■
PPPoE Log PPPoeControlPacket—Enabled or disabled
■
PPPOE duplicate-protect—Enabled or disabled
■
PPPoE ACNAME—Access concentrator name
■
PPPoE URL—URL sent in PADM message to PPPoE clients
■
PPPoE MOTM—Message of the minute sent in the PADM message to PPPoE
clients
■
PPPoE Service-Name Table—Name of the PPPoE service name table, if
configured for the specified profile
■
ATM1483 Auto-configure—Whether autodetection of the specified
upper-interface encapsulation type (bridged Ethernet, IP, PPP, or PPPoE) is
enabled or disabled for a dynamic ATM 1483 subinterface
■
ATM1483 lockout (seconds)—Encapsulation type lockout setting for the
specified upper-interface encapsulation type (bridged Ethernet, IP, PPP, or
PPPoE) configured on a dynamic ATM 1483 subinterface
■
range—Minimum lockout time–maximum lockout time, in seconds
■
no lockout—Encapsulation type lockout is disabled
■
ATM1483 PVC circuit type—Encapsulation setting for the PVC configured
on a dynamic ATM 1483 subinterface
■
aal5autoconfig—Enables autodetection of the 1483 encapsulation
(LLC/SNAP or VC multiplexed)
■
aal5mux ip—VC-based multiplexed circuit for IP only
■
aal5snap—LLC encapsulated circuit; the LLC/SNAP header precedes the
protocol datagram
■
ATM1483 PVC service category—Service type setting for the PVC configured
on a dynamic ATM 1483 subinterface: UBR (the default), UBR PCR, NRT-VBR,
RT-VBR, or CBR
■
ATM1483 PVC Peak rate—Peak cell rate (PCR), in Kbps, for the PVC
configured on a dynamic ATM 1483 subinterfaces
■
ATM1483 PVC Avg rate—Average rate, in Kbps, for the PVC configured on
a dynamic ATM 1483 subinterface; also referred to as sustained cell rate
(SCR)
■
ATM1483 PVC Burst size—Length in cells of the burst for the PVC configured
on a a dynamic ATM 1483 subinterface; also referred to as maximum burst
size (MBS)
612 ■
Monitoring Upper-Layer Dynamic Interfaces and Profiles
JUNOSe 11.1.x Link Layer Configuration Guide