Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 437 / 774

2.
(Optional) From PPPoE Service Name Table Configuration mode, create entries
to populate the PPPoE service name table.
You can configure up to 16 specific service name entries per table, in addition
to the empty and unknown service name tags.
host1(config-pppoe-service-name-table)# service myISPService action drop
host1(config-pppoe-service-name-table)# service myQOSClass1 action terminate
host1(config-pppoe-service-name-table)# service myQOSClass2 action drop
host1(config-pppoe-service-name-table)# service myQOSClass3
host1(config-pppoe-service-name-table)# service empty-service-name action drop
host1(config-pppoe-service-name-table)# service unknown-service-name action
terminate
These commands build the PPPoE service name table shown in Table 23 on
page 405. This table directs the router to send a PADO packet in response to all
PADI requests containing the myQOSClass1, myQOSClass3, empty service name
tags, and unknown service name tag. The router is directed to
drop all PADI
requests containing the myISPService or myQOSClass2 or the empty service
name tags.
Table 23: PPPoE Service Name Table with Entries
Action Service Name
Drop myISPService
Terminate myQOSClass1
Drop myQOSClass2
Terminate myQOSClass3
Drop “ ”
Terminate unknown-service-name
3.
Exit PPPoE Service Name Table Configuration mode.
host1(config-pppoe-service-name-table)# exit
4.
(Optional) Use the appropriate show command to verify the creation of the
PPPoE service name table and entries.
host1(config)# show pppoe-service-name-table name myServiceTable1
5.
(Optional) Repeat Steps 1 through 4 to configure additional PPPoE service name
tables on the router.
pppoe-service-name-table
■
Use from Global Configuration mode to create a PPPoE service name table.
■
You can create a maximum of 16 PPPoE service name tables per E Series router.
Configuring PPPoE Service Name Tables
■ 405
Chapter 12: Configuring Point-to-Point Protocol over Ethernet