Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 611 / 774

■
Use the no version to disable source address validation.
■
See ipv6 sa-validate.
ipv6 unnumbered
■
Use to enable or disable IPv6 processing on an interface without assigning an
explicit IPv6 address to that interface.
■
Example
host1(config-profile)# ipv6 unnumbered loopback 0
■
Use the no version to remove the IPv6 address from the interface.
■
See ipv6 unnumbered.
ipv6 virtual-router
■
Use to specify a VR in an IPv6 profile. Dynamic interfaces created with the profile
are assigned to this VR.
■
Example
host1(config-profile)# ipv6 virtual-router westford01
■
Use the no version to remove the VR assignment from the profile. If no VR is
specified via RADIUS, then any subsequent use of the profile to create a dynamic
interface fails for lack of a VR.
■
See ipv6 virtual-router.
l2tp policy
■
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
■
Example
host1(config-profile)# l2tp policy secondary-input my-policy
■
Use the no version to remove the association between a policy list and a profile.
■
See l2tp policy.
ppp aaa-profile
■
Use to assign an AAA profile to static and dynamic, multilink and nonmultilink
PPP interfaces.
■
The PPP application associates the AAA profile with the interface and passes the
AAA profile to AAA for authentication.
■
If an AAA profile is deleted after it has been assigned to an interface, AAA denies
the authentication and logs a message.
■
When you remove an AAA profile, it does not remove any corresponding bindings
between PPP interfaces or interface profiles and the AAA profile. If an AAA profile
Configuring a Dynamic Interface from a Profile
■ 579
Chapter 17: Configuring Dynamic Interfaces